Furnace Repair in Auburn, AL
Home › Service Areas › Auburn › Furnace Repair
January lows in Auburn average around 34°F, and a furnace that won't light or keeps shutting off makes for a cold night. Webb Heating and Air repairs gas or propane furnaces and electric furnaces throughout Auburn, including ignitors, flame sensors, gas valves, inducer motors and blowers. Call (334) 759-4722 and we'll find out why your furnace isn't heating.
Signs You Need Furnace Repair in Auburn
The furnace clicks several times before it lights, or never lights
Vent air feels cool while the furnace runs
You smell burning, metal or rotten eggs near the unit
The furnace starts and stops repeatedly without warming the house
Your carbon monoxide detector chirps or alarms when the heat is on
Common Furnace Problems We Fix in Auburn
Furnace blowing cold air because the burners never light or keep shutting down
Failed hot surface ignitors or dirty flame sensors on gas or propane furnaces
Inducer motors that hum, rattle or fail to start the ignition sequence
Short cycling caused by an overheating limit switch, often from a clogged filter
Blower motors that won't run, leaving the burners on with no air moving
Cracked heat exchangers and carbon monoxide concerns that need a safety inspection
How Our Furnace Repair Visit Works
We arrive, ask what you've noticed, and run a full diagnostic on the furnace, from the thermostat signal through the ignition sequence, burners, safety switches and blower. On gas or propane furnaces we inspect the heat exchanger and check for carbon monoxide risk. Before any repair, we explain what failed, your options and the price. After the fix, we cycle the furnace and confirm it heats safely. The service call is $100 during weekday business hours and $200 after hours and on weekends, both including the full diagnostic.
What Affects the Cost of Furnace Repair in Auburn
Furnace repair costs in Auburn come down to the part, the furnace type and the circumstances. A flame sensor cleaning or ignitor swap is smaller than an inducer motor, gas valve, control board or blower motor, and heat exchanger damage often leads to a repair-versus-replace talk. Older furnaces may need harder-to-find parts, tight closets and attics take longer, and a manufacturer's parts warranty can lower the bill. The service call is $100 during weekday business hours and $200 after hours and on weekends, including a full diagnostic, and we give you the repair price before starting.
Furnace Safety and Carbon Monoxide
Any Auburn home with a gas or propane furnace needs working carbon monoxide detectors near sleeping areas and on each level, tested twice a year. CO has no color or smell, so the detector is your warning. Inside the furnace, the heat exchanger keeps combustion gases out of your air, and age and heating cycles can crack it. Shut the furnace off and call if you see soot, a yellow or wavering flame, or rust and water near the burners. If the alarm sounds or anyone feels dizzy, nauseated or headachy, leave and call 911 first. Tenants should report a chirping detector right away. Every furnace repair visit we make includes a safety check as well.
Furnace Repair for Auburn Homes
Many Auburn homes heat with a gas furnace paired with central air, while some older houses and rentals near campus run electric furnaces. Furnaces in rental units often sit idle through the warm months, then get switched on for the first cold snap with a dirty filter and a dusty flame sensor. That first cold week is when no-heat calls pile up. Whether your home is in ZIP 36830 off US 29 or in 36832 closer to I-85, we test every furnace for safe operation, not just whether it lights.
Fall Tip: Run Your Furnace Before the First Cold Night
Auburn usually gets a few mild weeks in fall before the first real cold front. Use one of those days to switch to heat and run the furnace. If the burners don't light, the furnace shuts off quickly or the blower pushes cold air, call while it's still mild, not on the first freezing night, when many households call at once.
Furnace Repair FAQs for Auburn
Why does my furnace turn on and then shut off after a few seconds?
That pattern usually points to a dirty flame sensor, a failing ignitor or a safety switch tripping. The furnace is protecting itself by shutting the gas off. Cleaning or replacing the part often fixes it, but we test first to be sure.
Is it safe to run a furnace that smells like burning?
A light dusty smell on the first cold day is normal as dust burns off the burners. A strong burning, electrical or gas smell is not. Turn the furnace off, and if you smell gas, leave the home and call your gas provider before calling us.
Can you check my furnace for carbon monoxide problems?
Yes. Every furnace repair visit includes a safety check, and on gas or propane furnaces we inspect the heat exchanger for cracks. A working carbon monoxide detector near bedrooms still matters. If it alarms, get everyone outside and call 911 first.
Can a dirty filter really stop my furnace?
Yes. A clogged filter restricts airflow, so the furnace overheats and trips its limit switch, shutting the burners off. Over time that strain also wears the heat exchanger. Replace the filter every one to three months.
What should a healthy furnace flame look like?
On most gas furnaces, a healthy flame is steady and mostly blue. A yellow, orange or lifting flame can signal dirty burners or a combustion problem, so shut the furnace off and call.
More HVAC Services in Auburn
Furnace Repair in Nearby Areas
Furnace not heating in your Auburn home? Call (334) 759-4722.
