Furnace Repair in Salem, AL
Home › Service Areas › Salem › Furnace Repair
If your furnace won't light, keeps shutting off or blows cold air, Webb Heating and Air repairs gas or propane furnaces and electric furnaces in Salem 36874. We trace the problem to the part that failed, explain it in plain terms and fix it. Call (334) 759-4722 when your Salem home loses heat on a cold night.
Signs You Need Furnace Repair in Salem
The furnace clicks several times but the house never warms
A burning smell lingers long after the first few minutes of heat
Your carbon monoxide detector chirps while the furnace is running
The furnace cycles on and off every few minutes on cold nights
Burner flames look yellow or flicker instead of steady blue
Furnace Problems We Fix in Salem
Ignitor that glows weakly or not at all, so the burners never light
Dirty flame sensor that lets the burners light, then shuts them off
Inducer motor that hums, rattles or won't start the venting cycle
Gas valve faults that stop fuel from reaching the burners
Limit switch tripping from a clogged filter or a weak blower motor
Cracked heat exchanger concerns and carbon monoxide safety checks
What to Expect From a Furnace Repair Visit
When we arrive, we start with safety: we check for proper venting and look at the heat exchanger before anything else. Then we test the ignition sequence step by step to find where it stops. You hear what's wrong and what the repair costs before work begins. After the fix, we run the furnace through several cycles to make sure it lights, heats and shuts down properly. The service call is $100 during weekday business hours and $200 after hours and on weekends, and each includes a full system diagnostic.
What Affects the Cost of Furnace Repair in Salem
Furnace repair costs in Salem come down to the part, the fuel and the setup. A flame sensor cleaning is a smaller job than replacing an inducer motor, gas valve or control board. Gas or propane furnaces and electric furnaces use different parts, and older units may need parts that are harder to find. Access to the furnace and warranty status matter too. The service call is $100 during weekday business hours and $200 after hours and on weekends, both with a full diagnostic. We explain the price before any work begins.
Furnace Safety and Carbon Monoxide
Any furnace that burns gas or propane can produce carbon monoxide, a gas you can't see or smell. Every Salem home with a fuel-burning furnace needs working CO detectors near sleeping areas and on each level. The most serious fault is a cracked heat exchanger, which can let combustion gases into the air your blower moves. Flues blocked by bird or insect nests can do the same. If a CO alarm sounds, or anyone has headaches or nausea that ease outdoors, turn the furnace off, get everyone outside and call 911 or your gas or propane supplier. Once it's safe, call us to inspect the furnace before using it again.
Furnace Repair for Salem Homes Off the Gas Line
Many Salem homes along US 280/431 sit outside natural-gas service, so heat often comes from gas or propane furnaces or electric furnaces instead of a city gas line. Each has its own weak points. A furnace on a rural property may sit idle from spring to late fall, giving dust and insects months to settle on the flame sensor and burners. When January lows drop toward 34 degrees, that first cold-morning start is when ignitors and inducer motors tend to fail. We know these setups well, and we make the drive from Opelika to get Salem families warm again.
Fall Tip for Salem Homeowners
Before the first cold snap, run your Salem furnace for a few minutes on a mild fall afternoon. That first start burns off summer dust and shows whether the ignitor and flame sensor work while there's time to fix them. Check the flue cap outside for nests, and replace the filter, since a clogged one can make the furnace overheat.
Furnace Repair FAQs for Salem
Why does my furnace turn on and then shut off after a few seconds?
That pattern usually points to a dirty or failing flame sensor. The burners light, the sensor can't confirm the flame, and the control board shuts the fuel off for safety. Cleaning or replacing the sensor is a common and straightforward repair.
Should I worry about carbon monoxide from my furnace?
Any fuel-burning furnace deserves a safety check. A cracked heat exchanger or blocked vent can let carbon monoxide into the home. We inspect both during furnace repairs, and we recommend working CO detectors near bedrooms in any home that burns fuel for heat.
Do you repair electric furnaces too?
Yes. Electric furnaces in Salem homes use heating elements, sequencers and a blower instead of burners. We test each element and relay, check the blower motor and confirm the breaker and wiring are in good shape.
Can a low propane tank cause furnace problems?
Yes. A nearly empty tank can cause weak flames, failed ignition or lockouts. If your propane furnace won't stay lit, check the tank gauge first. If it's fine, we'll test the gas valve, ignition and safety controls.
Is it safe to use space heaters while my furnace is down?
Use them carefully. Plug them straight into the wall, keep them three feet from anything that can burn, and never leave them running unattended. Never use an oven, grill or generator indoors for heat.
More HVAC Services in Salem
Furnace Repair in Nearby Areas
If your Salem furnace has stopped heating, we can help. Call (334) 759-4722.
